Hello, In the "Mechanics" section of the forum, under the thread "Stepper motor," you talk about your "MKII" version of your DiyouPCB printer. You mention to one of the users that they should wait to build the printer until the "MKII" is completed. I was wondering if there is a timeline on the MKII or if you know when it will be finished? I don't mean to pry but I am very interested in both versions of the printer, and I am rather eager to see what kind of results you guys are able to achieve with the next version of the printer! Also, I am currently sourcing the parts to the prototype, and can't wait to put this printer together!Also, if I may make three sugestions. Wouldn't a more rigid frame construction help with some of the resonace? Maybe by doubling up on the shafts of the frame around the XY plane, each of the two shafts per side separated maybe by 20 or 30 mm in the Z direction. Secondly, I hear the GT2 belts and pulleys perform much better for backlash problems, as their construction is better suited for linear motion opposed to the T2.5 belts which are designed to be timing belts. Thirdly, I have read a little about using cork around the motors to dampen some of their vibrations, however, I am not sure how much this would help. Hope some of this can be helpful! In any case, thank you for all the work you are doing! I look forward to seeing the DiyouPCB MKII!!Best Regards,Nick