Here you will find a selection of our best pictures
Our RepRap with a laser "hot-end"
We installed the PHR803-T in the RepRap to do the first feasibility testing
The first prototype was perfect but it never worked...
So happens... We designed the printer with the X-axis belt in one side and the X-carriage never slided smoothly.
Some printed parts of the first prototype
We were a litle "unfocused"..testing different designing aproaches
Finally we move the X-axis belt to the printer center
X-axis slides smoothly if the motor push it from it's center.
The RepRap while printing DiyouPCB
We used it to print all DiyouPCB plastic parts.
Another printer view with the X-motor at the center
We laid the X-motor facing down to install the X-belt under the alu plate
The first printer prototype with printing bed and glass
It's starting to look like a printer....or a scanner.
were not very impressive. At the beginning all printings were blurry and the shapes deformed.
We tested different laser power and speed levels till we found the appropiates.
A blurry PCB
The firsts PCB testing, we were disappointed.
(c) 2013 Diyouware.com